LCR-Reader-MP: Multipurpose LCR and ESR meter

Newest model of LCR-Reader has more test modes, 0.1% basic accuracy,
and up to 100 kHz test frequency for measuring SMT

LCR-Reader-MPA has replaced LCR-Reader-MP.

LCR-Reader-MP is only available on TaoBao; limited stock

Latest Model of LCR-Reader Line

The newest model in the LCR-Reader line of handheld LCR- and ESR-meters is the LCR-Reader-MP; this model features a basic accuracy of 0.1%, more test modes and 100 kHz test frequency for a 0.01 pF resolution for capacitance and 1 nH for inductance measurements.

Analyze wave-forms

When using oscilloscope mode, the device is able to analyze wave-forms with frequencies up to 100 kHz on active circuit boards. The device can also be used with LCR-Reader Kelvin Probe Connector to check wave forms at various nodes on PCBs.

More Features

The LCR-Reader-MP has all the features available on Smart Tweezers ST-1 and more, including oscilloscope mode, pulse counting, AC/DC voltage measurements, signal generation, etc.

Measure Very Large Capacitances

The device is especially useful for measuring very large capacitances up to 600 mF. Electrolyctic capacitors are measured at 120 Hertz with ESR measured at 100 kHz according to regular electrolytic capacitor test conditions. The test frequency is reduced to 25 Hertz when using the ‘Large Capacitance’ mode, allowing to evaluate very large capacitances with reasonable accuracy. The LCR-Reader-MP offers a wide range of test frequencies for optimal test conditions. The frequencies are 25, 100, 120 Hz, 1, 10, 20, 30, 40, 50, 60, 75 and 100 kHz.

Larger Display / Better Readability

The device is larger than LCR-Reader and the newer models of Smart Tweezers. The LCR-Reader-MP weighs 2 oz., twice that of the other models. The larger size allows for a larger display for better readability. The device is controlled using a jog-wheel that scrolls through the extensive menus. It is powered by an Li-Ion battery with micro-USB charging.

High Test Signal Source Resistance

One of the downsides to the device is a high test signal source resistance of 1 kOhm and a maximum test signal level of 0.65 Vrms. This test signal level may not be enough for reliable measurements of some ceramic capacitors; this can lead to lower than actual capacitance values.

LCR-Reader MP

Features

Automatic LCR, ESR and LED/Diode measurements
0.1% Basic accuracy
Oscilloscope Transient Voltage display for up to 100 kHz
Measurements of Frequency, Pulse period, Duty Cycle up to 400 kHz
Signal Generator: Sine, Rectangle, Triangle pulse shapes up to 100 kHz
AC/DC voltage measurement up to 15 V
Diode/LED and Continuity test
Two Test Signal levels, Automatic Test Signal Reduction to 0.1 V for in-circuit measurements
Easy Short/Open Calibration, Offset Removal
Variable Test frequencies (25, 100, 120 Hz, 1, 10, 20, 30, 40, 50, 60, 75 and 100 kHz)
Display active and reactive impedance components
Can measure components to a 0201 size (about 0.3 mm)
2 Oz. (60 grams) weight
Li-Ion battery and micro-USB charger

LCR-Reader MP: Resources

Important Documents

Buy Online -Only available on Taobao